So the rear tailgate opening.... Fun times on that one!! So I stripped it back and found about three previous rust repairs... all minor and done fine, but one area isn't "factory look" which will irritate me so I'm pondering redoing it... However, I'll just put it in etch for now and worry about it later... THe other ones were in the lower beaver/valence area and done pretty well, even if a little wobbly... (you can make them out in the picture in the etch primer)... Not a big deal to fix, but another little job...

Takes a LONG while to strip this section... lots of nooks and little areas to get into (the taillight sections being obvious).

So stripped...

20230106_132222 (2).jpg

And in etch...

20230106_134120 (2).jpg

Hoping to get the front section done by tomorrow, or Monday at latest...