Non Sandman question re Belmont tailgate badge

[Geopaj]

Well, Murphy’s Law strikes again... I drove past this HQ ute parked on the side of the road yesterday so did a lap round the block and came back. I spent probably 6 months trying to solve this for myself before asking on the forum

It’s a Kingswood but I assume that the Holden would have used the same mounting holes for both Belmont and Kingswood.

Hopefully this helps you Innuendo, and also others in the future.



The ‘upright’ of the ‘d’ appears to be 30mm from the right hand edge of the tailgate.


Bottom edge of the silver strip lines up with the tailgate crease line. Look like the bottom of the font is 34-35mm above the crease line.

[AN5590]

It’s a Kingswood but I assume that the Holden would have used the same mounting holes for both Belmont and Kingswood.

From memory Belmont badges have 2 pins while Kingswood ones have 3 pins, that said I'm sure the badge positioning would be very similar in terms of the measurements to edge of tailgate etc.

[Geopaj]

From memory Belmont badges have 2 pins while Kingswood ones have 3 pins, that said I'm sure the badge positioning would be very similar in terms of the measurements to edge of tailgate etc.

AN5590, a quick search of second hand badges on eBay confirms you are right!