HZ key barrel not fitting properly

[Innuendo]

My steering wheel is of. Can I remove the indicator switching gear and then assess the ignition barrel without removing the steering column?

Yes, the slot for the depress is in the upper honey pot positioned near where you would visualise the barrel is internally. Sometimes there is still a very thin layer of die cast if it has never been removed before. Just push the flat blade through it.

honey_pot_barrel_slot.jpg

[Dawso]

Innuendo you were spot on. I got the nice shiny barrel out and what a heap of crap it is. I compared it with a genuine barrel, it's tight and built like a tank. I'm sure the other was a knock of. Anyway the geniune stainless steel replacement fits like a glove. I appreciate your help.

[Innuendo]

Innuendo you were spot on. I got the nice shiny barrel out and what a heap of crap it is. I compared it with a genuine barrel, it's tight and built like a tank. I'm sure the other was a knock of. Anyway the genuine stainless steel replacement fits like a glove. I appreciate your help.

Glad you got a result!

[Dawso]

[If you have a 4 digit code on a genuine barrel I can factory punch cut a genuine GM key for your barrel.[/QUOTE]

Innuendo I only have one genuine key, would it be possible to organise with you to have a couple of spares cut?

[Innuendo]

[If you have a 4 digit code on a genuine barrel I can factory punch cut a genuine GM key for your barrel.

Innuendo I only have one genuine key, would it be possible to organise with you to have a couple of spares cut?

Sure no a problem at all. I have sent you a private message with instructions.