Holden did put shrouds on all v8’s In WB.
Holden did put shrouds on all v8’s In WB.
That is true but it was also with a different radiator design and recovery unit.Originally Posted by wbute
Selling HJ 253 Engine
Engine Number QR718*** | 19M5 Clock Casting at 6 O'Clock
19th December 1975 Suit HJ Late Dec 1975 to April 1976
Probably said a bit about the old vertical flow design as they went away from it to cross flow in WB. The WB still had exactly the same room and airflow as the earlier series. Clearly a move with the times.
My old wb used to get hot with air conditioner running but was fine with it turned off I have always wondered why ?
Was it factory air or dealer fitted?
Early Holden aircon was never much chop
It didn’t make them run hot though. Mine won’t run hot enough with the cooler thermostat in it.
A radiator specialist should be able to pressure test the system for a start. Secondly the CPC catalogue recommends a 15lb cap as they supplied to GMH originally. It should be a coolant recovery cap. You can clean around and underneath the small circular valve plate. The slightest dirt can cause it to lose pressure easily which then reduces the boiling point. Keep an eye on the recovery bottle to ensure it is working properly and should be reasonably clean water.
It was factory
Mine sit on the half way mark when warm slightly above when hot this is after a recent flush and new coolant
There are currently 3 users browsing this thread. (0 members and 3 guests)
Posting Permissions
Reply With Quote
Bookmarks