Hi guys needs some ideas
308 with around 100psi on each set of heads (just a quick rough test #1 and #2. Obviously compression is low but a couple mechanics have told me that should be enough to run. The car has been sitting for years. IT came off the road after the inlet manifold let go and water went in the oil. Heads look too clean to be the ones that were on the block when things went pear shaped. I think last owner may have changed them or at least given them a good clean. I have fuel (too much actually i think) and have spark. Does not even come close to firing. I have had this problem so many times and I have no frikken idea! Fuel, spark but won't run!

I'm going to take fuel line off and just try it on 'start ya bastard' to strike off flooding.

any suggestions? thanks..again

also how can i tell if the block is a 76 or 86? it has elec ignition and blue paint but could have been painted blue as it's in a WB.