Other way round I think, top, sides, then bottom. Just don't tighten the screws completely until the next piece in place
Other way round I think, top, sides, then bottom. Just don't tighten the screws completely until the next piece in place
Either top or bottom first doesnt matter.I fit the pieces from left first so the right side overlocks in the cenre.You can join them together before fitting but i find the first way better.The sides are fitted by putting the top off the side under top mould and base on top off bottom mould.Line up screw holes and fit short suitable screws EASY Dont use longer screws than needed because they will go thru and crack the edge of the screen.ps have small brush and black touch up paint
Absolutely 100% correct in every way. I did my white van a month or so ago and that sounds like what I did.
It doesn't hurt to put some masking tape at the points where the pieces ALMOST overlap so if you go a bit far pushing them together it won't scratch the powder coat
Vans.... This is the 2nd time round the block, 40 years later! talk about turning back the clock!
Thanks everyone for your help. One of the last things to go on, didn't want to stuff it up !!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks