It would appear that some knob has built my HX van with a 1 tonner diff mated to a std V8 drive shaft. My question is can I simply install a 1 tonner drive shaft behind an M20 gearbox? or is there an 'adaptor' universal joint I could install
cheers
It would appear that some knob has built my HX van with a 1 tonner diff mated to a std V8 drive shaft. My question is can I simply install a 1 tonner drive shaft behind an M20 gearbox? or is there an 'adaptor' universal joint I could install
cheers
I'm sure I have seen them on eBay. They do exist.
Kings wood country has them.
Last edited by jason.ruff; 04-11-2016 at 03:24 AM.
ive bought them in the past its a uni joint that has the 2 different sized cups i can dig up the part number if you have no luck elsewhere
One tonner shaft is a bit longer I think. Pretty sure there are 3 different sizes.
Sedan Coupe
Wagon Statesman Ute Van
1 tonner.
There a fair few different ones. Turbo 400 are shorter etc.
I believe repco sell an adaptor uni with the different sizes up and across. tonner tailshaft is longer
I have a one tonner diff fitted in my van and it uses an adpter uni joint.
Hardy Spicer Part # RUJ-2034
Have a look at page 7 on this link.
http://www.hardyspicer.com.au/PDF_Fi...hanics%20R.pdf
Hope that helps
Thanks guys, that has made the job a lot easier, cheers
i have a 3.08 tonner diff and there is in and out slop in the axles. anyone know what causes this?
BQZ
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks