WB chassis under a HQ

[Big Rob]

I don't think that the RMS will allow a SBC into HX-WB, but things like extractors & Holleys etc. on any old 6/253/308 quite often 'go under radar' as far ADRs are concerned.

Many inspectors don't have the knowledge of the intricate differences between all the variations of ADR27/A/B etc. on all the different engine & transmission combinations. Also a lot of the necessary documentation is no longer easily accessible.

As long as the cars looks good & runs well & isn't blowing smoke or leaking oil & the engine is from approximately the correct era, it will pass.

Dr Terry

Yeah, that's pretty much where I was going with my comments.

I remember about 8 years ago I took my LX Torana for an inspection to a mates garage and was a bit worried he might not like the Holley, etc.
He didn't even bother looking at that, but was really concerned that the ignition key could be taken out of the switch with the ignition in the on position! I asked him what regulation that was covered by and he pointed at the compliance plate and said " That one.... ADR27a". I said to him that that was for emissions and he said "No.... that's for the ignition key"!

Whatever.....

[HK1837]

You can reasonably easily get a SBC Engineered in HX-HZ Terry, but as you say you shouldnt readily pass a blue slip with one. But with a HQ-HJ it isn't necessary to get Certification, hence my comment about the later chassis with SBC.

[playwme]

thanks for the info , I can get a WB chassis cheap , but it's in Bendigo , and would prefer to find a HZ roller chassis close to Canberra if any body has one , cheers

What do you call cheap?
Are you looking for one with V8 diff?

[outlaw67]

Free , a mate has a couple of WB Pano's sitting on a property down there , and a salisbury would have been handy