Wanted Upper Tailgate

[Duc1991]

I am looking for an upper tailgate in better condition than the one I have pictured.Sandman Resto _13 002.jpgSandman Resto _13 003.jpg
any help appreciated.

[Vombil]

if you're very patient you will find one.. or you might just get lucky. ill keep an eye out over here my friend

[Big Rob]

Fibreglass one from the guy in Melbourne is a good bet, that's what I'm doing.....

[Valencia]

If thats the only bit thats bad cut it out and just make a new piece

[Duc1991]

if you're very patient you will find one.. or you might just get lucky. ill keep an eye out over here my friend

Thanks Vombil

- - - Updated - - -

If thats the only bit thats bad cut it out and just make a new piece

No Valencia there are lots of bad bits.

- - - Updated - - -

Fibreglass one from the guy in Melbourne is a good bet, that's what I'm doing.....

Thanks Rob. Didn't want to go fibreglass but could you give me contact details anyway.

- - - Updated - - -

I am looking for an upper tailgate in better condition than the one I have pictured.Sandman Resto _13 002.jpgSandman Resto _13 003.jpg
any help appreciated.

What approach have other people taken?
Besides the large amount of rust that I have highlighted, there are cracks where the strut brackets are, big cracks where the slider rods go, other rust areas around the rubber seal and lots of uneven parts and depressions on the outer panel.

[Vombil]

you need to look at taking the skin off the frame and really treating the problem from the inside out. once skinned you can weld the cracks to the brackets and treat rust inside. also easier to plate it when it's apart. lots of work. i wouldn't recommend it as if you search hard enough and cough the right kinda $$ one will appear.

[Duc1991]

you need to look at taking the skin off the frame and really treating the problem from the inside out. once skinned you can weld the cracks to the brackets and treat rust inside. also easier to plate it when it's apart. lots of work. i wouldn't recommend it as if you search hard enough and cough the right kinda $$ one will appear.

I know it's a lot of work. My panel beater said to do it properly it would be a lot of work. I have been looking for a while and am still following a a few leads. Amazingly years ago they were everywhere.

[rocky]

ring abloke for you monday

[Duc1991]

Thanks rocky

[Big Rob]

Ring him for me too!