Long way to go, but you'll get there......
Long way to go, but you'll get there......
Vans.... This is the 2nd time round the block, 40 years later! talk about turning back the clock!
Looking good. What paint did you use on the wishbones? I did mine the same way (almost identical masking tape) I painted mine up before getting the bearings pressed in, but the shop scratched the paint up a bit (which I expected) so I masked up exactly the same way for the touch up. Nice looking work.
I painted the chassis and front end parts with holdens tuxedo black. 2 PAC of course. It's the same black I will use for the black outs so I brought extra. It a nice gloss black I have used on cars before.
Neat!
Got a whole side bare metalled. I'll hopefully etch the whole body this weekend... If I keep on the sander. I've got a big acid tank at work the nose cone, guards, tailgates and doors should all fit in.
image.jpg
image.jpg
image.jpg
UPDATE: the 308 is painted. Inlet and timing cover were sandblasted and painted with clear coat... This makes cleaning a breeze. The drivers side rocker cover is beaten up so I'm looking for a better one. I'm holding off on the body work until the weather warms up a bit. Fresh set of extractors. New dizzy.
Last edited by rathyhg; 22-06-2015 at 09:34 PM.
what dizzy did you go for ? I have just purchased an RAE, yet to install though
Vans.... This is the 2nd time round the block, 40 years later! talk about turning back the clock!
Dizzy is a thunder max. There on evilBay.I've had these before with absolutely no problems....
unlike a certain other brand I've purchased before����
http://i12.photobucket.com/albums/a2...psjylfzplc.jpg
I've got the engine looking good.
http://i12.photobucket.com/albums/a2...psghxubpnv.jpg
the reco diff and springs painted up new bushes in the rear
There are currently 7 users browsing this thread. (0 members and 7 guests)
Posting Permissions
Reply With Quote
Bookmarks