Original setting for rear springs

[Wombat7051]

I hope someone can help me, I took the HZ springs in today to be reset to original. I need to find out the original camber of the springs. This is the distance between a straight line draw between the eyes down to the bolt in the centre of the spring. Thanks

[HK1837]

I have the following:

HZ ute/van standard springs, part numbers 9935933 & 35 (LH & RH):

Primary x 3 @ 8mm, secondary x 1 @ 13mm.

Primary RH: 3270nM @ 66mm camber.
Secondary RH: 6565nM @ 13mm camber.
Primary LH: 2800nM @ 66mm camber.
Secondary LH: 6065mm @ 13mm camber.

Primary rate is 29.3 kN/m
Secondary rate is 51.8 kN/m.

This is straight from the HZ features manual.

[Wombat7051]

I have the following:

HZ ute/van standard springs, part numbers 9935933 & 35 (LH & RH):

Primary x 3 @ 8mm, secondary x 1 @ 13mm.

Primary RH: 3270nM @ 66mm camber.
Secondary RH: 6565nM @ 13mm camber.
Primary LH: 2800nM @ 66mm camber.
Secondary LH: 6065mm @ 13mm camber.

Primary rate is 29.3 kN/m
Secondary rate is 51.8 kN/m.

This is straight from the HZ features manual.

Thanks for your help Byron I was probably being lazy by asking rather than looking but I am at work and the books are at home. I need to ring the guy and let him know so they can be done for when I get home.
Thanks again.