HZ Van Persian Sand MKII

[Absinth]

Interesting .....

http://www.ebay.com.au/itm/50x-Stron...AAAOSwstxVfmSK

These are especially good if you can't get access to the rear of the panel to do up panel clamps...

[Wombat7051]

This is the place I got mine from,

http://www.metalmantools.com.au/hika...ng-clamps.html

As absinth says the magnets would be great if you cant get behind the panel. One of my big problems with the clamps is the square rod at the back falling out when you are attaching or moving them.

[Gm nut]

http://www.ebay.com.au/itm/50x-Stron...AAAOSwstxVfmSK

These are especially good if you can't get access to the rear of the panel to do up panel clamps...

Man, they are cheap hey!
Ordered a set, for next project....thanks

[Absinth]

Man, they are cheap hey!
Ordered a set, for next project....thanks

Just make sure you keep the panels clean of metal filings and grinding dust, the magnets are bugger to clean. I always brush down my work area and give cavity areas a quick vacuum before final fit of the patch and welding.

[Gm nut]

Just make sure you keep the panels clean of metal filings and grinding dust, the magnets are bugger to clean. I always brush down my work area and give cavity areas a quick vacuum before final fit of the patch and welding.

Sound advice

[ambientgoat]

This is the place I got mine from,

http://www.metalmantools.com.au/hika...ng-clamps.html

As absinth says the magnets would be great if you cant get behind the panel. One of my big problems with the clamps is the square rod at the back falling out when you are attaching or moving them.

Do you remember, is that price per clamp?

[Wombat7051]

Well I turn my back for 1 minute and go to work and the father in law sends me this
IMG_0758.jpg
IMG_0759.jpg
As he said best to get all the rust spots now then have them come through in 12 months time.

- - - Updated - - -

Do you remember, is that price per clamp?

I think it was per clamp but they may do it cheaper in bulk.

[XX7SANDMN]

wow that's huge best be ordering a few more clamps and a spare roll of mig wire

[Wombat7051]

wow that's huge best be ordering a few more clamps and a spare roll of mig wire

I think i might go with the magnets, tig welder and fuse weld on this to reduce the heat, but yea will be a big job.

[Gm nut]

Well I turn my back for 1 minute and go to work and the father in law sends me this
IMG_0758.jpg
IMG_0759.jpg
As he said best to get all the rust spots now then have them come through in 12 months time.

- - - Updated - - -


I think it was per clamp but they may do it cheaper in bulk.

Keen!