What are these and where do they go?

[sandman77hx]

image.jpg

Hopefully the photo has attached. Am not sure what these are as both the vans I've bought have been dismantled and both have them. Any help would be greatly appreciated.

[Wombat7051]

From memory they look like the pieces that hold the rubber at the rear of the bonnet on the top of the firewall. I think

[Taily]

The go in front of and either side of the cowl grille. They function as end plates to hold the rubber seal (seals the rear of the bonnet) down either side of the cowl grille. You cannot see them in this shot but they sit flat outboard of each end of the grille and the small folded part holds the ends of the rubber flat - the rubber slides under them to a point.

V8ed_hz.jpg

Dave.

[sandman77hx]

Thanks so much

[Cocko750]

Hey mate not sure if it was you looking for a cb radio ,( doin a het replica )but will check at dads shed tommorow and let you know.

[XX7SANDMN]

have got few different lenght sets possibity longer on the i tonners

[mauser]

Hq and 1-tonner ones are different from HJ-Z I think.

Mauser

[sandman77hx]

Hey mate not sure if it was you looking for a cb radio ,( doin a het replica )but will check at dads shed tommorow and let you know.

Hey Cocko. Only just now saw your post so apologies for the late reply. It wasn't me looking for the CB however may have been Rallyvan.