Removing ignition barrel ..explained

[ozbox]

Firstly you need to remove the steering device..then you will be staring at this...



Then you need to remove the switching stuff which is held on with screws..you will work it out..:eek:
You will then be staring at this and it may confuse some because there is no slot to put your thin screwdriver or knife into to release the barrel..this van had its original ignition..you need to poke a hole thru the alloy as per the pics below..





You also need to have the ignition in the off position..not lock or accesories but off..1 back from when the red dash lights should be on..



Then you can poke at the slot and pull out the ignition barrel with the other hand...thats if its being nice to you..if its not use a larger flat head screwdriver to lever the ignition barrel out slightly..





This is exactly the same removal procedure for all models hq to wb and also lj to uc torana and vb to vl commodores.