I have the cross over linkage if you are still interested. All you need is the bar from a trimatic and the mounting plate (which I'm quite sure I have both)
P.M. If still interested. They are almost impossible to find!
There is also a little bracket but i couldn't find it.. I think I have a few too many linkages.. but the important bit is there for the cross over.
stolen from oldholden.com
Last edited by mook; 04-03-2013 at 02:05 PM.
hello the trimatic shifter even when the pin is taken off and swapped the other way will not work properly , the angle is wrong compared to the t400 and getting a t400 rod would not make a difference. cable setup sounds like a good idea but are hard to get ?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks