Mrs Mook's HZ Prem

**playwme** · 10-01-2013, 08:55 PM

You could whack a VH lion boot lock surround on to cover the mess. I remember seeing little rectangle stick on ones as well with all the different logos for different vehicles.

http://www.ebay.com.au/itm/HOLDEN-VH...#ht_3001wt_922

**mook** · 10-01-2013, 09:32 PM

Originally Posted by agr071

Nice colour by the way.

What is the colour? I Have not even looked at the tags..

Originally Posted by playwme

You could whack a VH lion boot lock surround on to cover the mess. I remember seeing little rectangle stick on ones as well with all the different logos for different vehicles.

http://www.ebay.com.au/itm/HOLDEN-VH...#ht_3001wt_922

I think I have seen a rectangular version of something similar, I remeber horizontal lines then the lion..

http://www.ebay.com.au/itm/COMMODORE...item3ccd50336b
This looks tidier.. whats the diameter of a lock. I currently have non. lol

I'm also chasing a horn insert for the steering wheel, if any one has one i would be grateful.

**mook** · 11-01-2013, 12:48 AM

Originally Posted by HK1837

Welcome to the Premier Sedan club! Is it a Pagewood build? Looks like it might be an original Pagewood vinyl roof installation.

202 column shift or T-bar?

Will the paint buff up OK? If yes, you might just have to tidy the boot lock hole area up best you can using a dolly and hammer, and paint a small area of matt black around the lock. You won't really notice it with the badge and mould either side of it.

Here are the side moulds: http://www.ebay.com.au/itm/holden-pr...item27ceb8cb5c

Clips to hold them on look to be 7434212. Might have to find secondhand ones. HZ Kingswood SL, Premier

Are these the clips you speak of?
http://bit.ly/RHPyuY

**Vombil** · 11-01-2013, 12:59 AM

sweet rides guys!

HK looks like that driveway has seen a few oils changes over the years!

**HK1837** · 11-01-2013, 06:07 AM

Originally Posted by mook

Are these the clips you speak of?
http://bit.ly/RHPyuY

I don't think so, I think those go on the front of the rear door mould where it gets skinny to clear the front door when open. Hence why only two per car.

**HK1837** · 11-01-2013, 06:08 AM

Originally Posted by Vombil

sweet rides guys!

HK looks like that driveway has seen a few oils changes over the years!

It is just wet. I don't think it has ever had oil on it!

**adam perth** · 11-01-2013, 11:56 PM

the side strip plastic clips for HZ are the same as WB. full sets from RS , my last set cost $32.

**HK1837** · 12-01-2013, 08:18 AM

Adam, do they actually fit? They are a different part number.

**mook** · 12-01-2013, 03:18 PM

Just found the Origenal receipt. All matching numbers as well. Cool!

I grabbed some yesterday, heres hoping...

**mook** · 12-01-2013, 07:45 PM

Now here is a tricky problem....
Ambientgoat and I got the prem up and running last night after discovering that the hose from the pickup to the hard line had perished. This was replaced and then the engine could get fule and be started. The car has been sitting 24 hours and now it won't start? We did change the file pump to one without the glass float. I'm sure that the Origenal one was fine but just couldn't suck the fuel through because of the crusty hose.

A lot of the vaccum hoses are very crusty in the engine bay would this make a difference?

Cheers,
Mook

New pump

Plus goat primed the lines 'manually'