HX & HZ Sandman blackouts

[agr071]

Just wondering if anyone has any detailed photo's of where the blackouts go on the HX & HZ vans?
What i mainly need is:

a) Where they go on the body behind the doors
b) How far up the rear guards do they go
c) Where abouts they go when near the rear bars on the sides

Thanks in advance

[sandmanowners]

Just a note on sill blackouts, the factory black out lines are actually slightly higher than that of the sill seam. This is done to hide the shadow gap created under the doors. So if you were to run a tape line from the underside of the door edge you should be pretty right. It does look weird if you just go from the sill seam.

If you look at the pic below you'll see what I mean.

sandman 006.jpg

[sandmanowners]

Approx 10mm above sill line.
rust-cut-out-rear-drivers-sill.jpg

[sandmanowners]

Attachment 4936
Attachment 4937
Attachment 4938
Attachment 4939
Attachment 4940
Attachment 4941
Attachment 4942
Attachment 4943

[agr071]

Thanks for that.
I didn't realise about the sill stripes - HANDY INFO
UNFORTUNATELY the pics in post #4 can't be seen.

[sandmanowners]

Did that work ?

[agr071]

That's better..
Thanks

[sandmanowners]

I went through all my files and found those few cars with original paint still on them. The rear quarter blackout starts behind rear wheel same height as sill blackout and runs up to where the corner of the bumperette starts. Blackouts wrap around lips on wheel arches. HX only has nosecone blackout, HZ doesn't as it has the air dam. B pillar blackout is hard to explain! finishes close to where the curve meets the flat....

[agr071]

Thanks for your help.
It's greatly appreciated. :cheerful: :cheerful: