Hj Kingswood Sandman Rebuild

**Cocko750** · 24-11-2015, 11:18 PM

Originally Posted by Valencia

At least this way its all brand new

They seem to be a great setup , which size unit was it (compac- mini-or full size)and did they give a choice of controls, the ones I have seen advertised showed a control that looks the same size as the original control.

**tup39** · 24-11-2015, 11:24 PM

Originally Posted by Cocko750

They seem to be a great setup , which size unit was it (compac- mini-or full size)and did they give a choice of controls, the ones I have seen advertised showed a control that looks the same size as the original control.

Compact mini this one was and yes lots of choices of controllers.

**Valencia** · 24-11-2015, 11:37 PM

You couldn't post a pic of the switch and where your going to install it by any chance

**tup39** · 24-11-2015, 11:54 PM

Originally Posted by Valencia

You couldn't post a pic of the switch and where your going to install it by any chance

Used this one,sits in that small shelf
IMG_3283.JPG

**Valencia** · 25-11-2015, 12:57 AM

Pretty factory looking at that good spot

**Big Rob** · 25-11-2015, 02:03 AM

Yeah. Good use of that spot.

**Cocko750** · 25-11-2015, 06:50 AM

Originally Posted by tup39

Used this one,sits in that small shelf
IMG_3283.JPG

That looks good and uses that shelf but I was thinking this one but maybe a little big to fit in original hole 118 x62 image.png

**tup39** · 25-11-2015, 09:48 AM

Was my next choice,think you could make it fit ok without to much trouble

**Vombil** · 25-11-2015, 10:13 AM

Originally Posted by Valencia

Whoa 2.5 k jesus christ

mate you've been hiding out too long. a buddy of mine in wa was quoted 4.5K to have aftermarket a/c installed in his hx sedan

**stickthis** · 25-11-2015, 08:43 PM

Originally Posted by Cocko750

Yes Jason there's an efi engine in it , Ido have a full set up off a vk compressor and alt on drivers side also have the power steer pump but not sure yet . Also can cut off and reweld throttle body on more of an angle but not real keen on that , but it has been done by someone on here( sorry can't recall who). I think the kit is everything included but the gas , so that's where the cost is , I was looking at just the unit and control there is a few different sizes and the new ones are all electronic servos ,which I've seen for between $800 & $1000 use my ac brackets and own hoses condenser and r/drier.

Im considering going the same way. I have mates that can gas it. Also can get all the standard gear at trade prices. So im considering buying the unit and fitting it. And maybe the controls also. As like you say on an efi eng its a different setup.... hmm.

don't get me wrong 2.5k isn't too bad though.