Thanks Blocker but they don't have the detail I need. I'd like a pic from the side...square on.....not the pics that show an angle view because they just dont give the defintion required.

--- Updated ---

Thanks Q Set...I've come to the same conclusion. After thinking about it for a while in my pondering chair I figured that the thin taper end had to go to the front otherwise the strip wouldn't go under the fuel cap. I reckon if it went the other way it would pass over the bottom half of the cap and I haven't seen that in any of the pics I've looked at. I'm going to mock it up in the morning and check my/our theory. As far as actually fitting them goes I'm getting my "experienced" sign guy to do them.