Tie Rods

[hj308]

Thanks Bigcav

[MemoryLane-Spare-Parts]

99.9% of our hard suspension parts are Roadsafe brand, where roadsafe get them from im not sure, i beleive alot of there parts are 555 parts rebranded but im not certain of that. some stuff is also wasp brand.

our suspension rubbers can be a mix or ours or mackay depending on the part and its popularity

just to let you know

Hi You can all so TRW tie rod and ball joints they are highter end quality

[sandman 78]

kingswood country on ebay sell set of 4 tie rods for the cost of $45 plus postage lm not sure what brand but there prices are preety good not chinees stuff has any body bought from them

[buck]

I have just done up the front end in my wb ute, Drag link, idler arm, ball joints, bushes, tie rods, went down to the local Bursons and they had every single bit in stock, could not believe it!

Bursons Geelong
22 Mercer Street Geelong VIC 3220
(03) 5222 4900

[wbute]

Ball joints, anyone make decent ones yet?

[hainzy]

Ive just replaced my lower ball joints and used MOOG brand which you get from all americam autos. I believe theyre used on camaros but the suspension guy in ballarat swears by them for HZs etc...

[MemoryLane-Spare-Parts]

Ball joints, anyone make decent ones yet?

Hi i have been selling spare parts about 25 years now i have watched ball joints and tie rod ends go form high quality to crap so i started my own shop so my suspension are made in the USA or JAPAN i started to listen to what pople so i started import top end parts like TRW and MOOGE front end parts

[cafiem]

kingswood country on ebay sell set of 4 tie rods for the cost of $45 plus postage lm not sure what brand but there prices are preety good not chinees stuff has any body bought from them

Yep, I got the whole kit, about eight million parts from memory. The quality looks good but the ute isn't on the road yet so I don't know for sure.
Actually I have bought a bit of stuff of them and everything looks OK.
I bought a gearbox input shaft, the front end kit and some trim stuff I think, yes it was their rubber kit.

[RodneyHZ253]

I purchased to set from my local auto shop aa Blatch in Parkes I insisted the they source better quality and make sure that the nut with them was a crown head nut for spit pin and not a nurapene look nut might have a look at the box today and add brand latter

[Taily]

Hi i have been selling spare parts about 25 years now i have watched ball joints and tie rod ends go form high quality to crap so i started my own shop so my suspension are made in the USA or JAPAN i started to listen to what pople so i started import top end parts like TRW and MOOGE front end parts

So what brand of BJ 54/55's are you flogging and for how much?